Back to back G.SHDSL configuration

Unanswered Question
Jul 2nd, 2007
User Badges:

Hi all


I have 2 X cisco 2811 routers with hwic-2shdsl cards

I need to setup a SHDSL back to back connection.

IOS ver 12.4(11)xj


I have a RJ11 cable plugged into both SDSL interfaces - i just need a sample config to continue.


Can anyone help me?


Regards


Hennie



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
h.botha Mon, 07/02/2007 - 01:00
User Badges:

Hi Mohammed,


I looked at this document previously, there are a number of commands that are not supported on my combination of hardware/IOS.

- DSL Equipment type- etc


Any other ideas


cheers

Hennie

mohammedmahmoud Mon, 07/02/2007 - 01:13
User Badges:
  • Green, 3000 points or more

Hi,


No, i guess that your only chance is to use the appropriate IOS to have it done.


HTH,

Mohammed Mahmoud.

h.botha Mon, 07/02/2007 - 01:18
User Badges:

Hi Mohammed,

Thanks i have checked - the only ios to support the hardware configuration is 12.4(11)xj.

Which is cuurently on the hardware.


Regards

Hennie

mohammedmahmoud Mon, 07/02/2007 - 01:30
User Badges:
  • Green, 3000 points or more

Hi,


Weird ! i've tried this configuration once before on a Cisco 2600 series running 12.3T, and it worked (the "dsl equipment-type" command is applied under the interface not on the global configuration mode), any way i'll try testing it on a 2800 router and feed you back.


HTH,

Mohammed Mahmoud.

h.botha Mon, 07/02/2007 - 03:23
User Badges:

Hi,


I will await your feedback/testing.


Regards

Hennie

lvigh Thu, 01/31/2008 - 06:02
User Badges:

Hi, Hennie



I have the same problem as You. Do you have any solution?




Best Regards,

Loj


abolfathi_0248 Wed, 04/16/2008 - 05:36
User Badges:

Hi

i have same problem.it take too much time for me.i think the problem are :


1-you need to upgrade your current IOS to 12.4T(6) or later.

2-i think only Cisco ISR-878 G.SHDSL and old G.SHDSL-v3-WIC (not HWIC) support back-to-back

3-FAQ for G.SHDSL HWIC mentioned that back-to-back only supported on 4-pair G.SHDSL only to diagnostics perpose.

4-i am wonder while G.SHDSL HWIC use the same ITU G.991.2 standard , why back-to-back not supported

Actions

This Discussion