cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2381
Views
10
Helpful
4
Replies

Cannot log into Cisco 2800 router. Please help!

djgizmo250
Level 1
Level 1

Please help. I can't log into our 2800 router. I tried the using cisco for the username and password, but it doesn't work. How can I tackle this? Is there a way to reset the username and password?

-----------------------------------------------------------------------

Cisco Router and Security Device Manager (SDM) is installed on this device.

This feature requires the one-time use of the username "cisco"

with the password "cisco".

Please change these publicly known initial credentials using SDM or the IOS CLI.

Here are the Cisco IOS commands.

username <myuser> privilege 15 secret 0 <mypassword>

no username cisco

Replace <myuser> and <mypassword> with the username and password you want to use

.

For more information about SDM please follow the instructions in the QUICK START

GUIDE for your router or go to http://www.cisco.com/go/sdm

-----------------------------------------------------------------------

User Access Verification

Username: cisco

Password:

% Login invalid

Username:

4 Replies 4

I followed the procedure in the link above. The procedure states that you cannot re-use the encrypted passwords. Is there a way that I can use the same passwords?

I am having the same issue today. I changed teh configuration but didn't change the username and password. so I am stuck. I am not close to the system so I could not try but someone sent me the following message:

You can do password recovery.

Follow the procedure on this link.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml

Thanks for all your help guys! I went through both procedures and it didn't work. I kept getting the same banner and prompt below. I ended up doing a write erase and started fresh.

-----------------------------------------------------------------------

Cisco Router and Security Device Manager (SDM) is installed on this device.

This feature requires the one-time use of the username "cisco"

with the password "cisco".

Please change these publicly known initial credentials using SDM or the IOS CLI.

Here are the Cisco IOS commands.

username privilege 15 secret 0

no username cisco

Replace and with the username and password you want to use

.

For more information about SDM please follow the instructions in the QUICK START

GUIDE for your router or go to http://www.cisco.com/go/sdm

-----------------------------------------------------------------------

User Access Verification

Username: cisco

Password:

% Login invalid

Username:

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco