CatOS help

Answered Question
Jul 2nd, 2007

Hi,

I am trying to view the interface configs and vlan assignment for interfaces on a Catalyst 4006 with CatOS but I am unfamiliar with CatOS commands. Can someone point me in the right direction?

-Shikamaru

I have this problem too.
0 votes
Correct Answer by Edison Ortiz about 9 years 6 months ago

Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.

The command is show arp.

Correct Answer by Jon Marshall about 9 years 6 months ago

Hi

To view the mac address table in CatOS

"sh cam dynamic"

You can also put in specific ports, do a

"sh cam ?"

HTH

Jon

Correct Answer by Jagdeep Gambhir about 9 years 6 months ago

Hi Shikamaru,

Here is the command,

Switch> (enable) sh port 3/1

Check this link

http://www.cisco.com/warp/public/473/53.shtml#Show_Port_for_CatOS_and_Show_Interfaces_

Please rate if that helps !

Regards,

`JG

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
shikamarunara Mon, 07/02/2007 - 17:52

Is there a way to see the MAC address table and ARP table in CatOS? I found a command that looks like it should give me the information (show port x/y), but it doesn't have any MAC addresses in it. I'd just like to know what IP addresses are connected to each interface.

-Shikamaru

Correct Answer
Jon Marshall Mon, 07/02/2007 - 22:06

Hi

To view the mac address table in CatOS

"sh cam dynamic"

You can also put in specific ports, do a

"sh cam ?"

HTH

Jon

Correct Answer
Edison Ortiz Tue, 07/03/2007 - 05:30

Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.

The command is show arp.

Actions

This Discussion