07-02-2007 01:33 PM - edited 03-05-2019 05:05 PM
Hi,
I am trying to view the interface configs and vlan assignment for interfaces on a Catalyst 4006 with CatOS but I am unfamiliar with CatOS commands. Can someone point me in the right direction?
-Shikamaru
Solved! Go to Solution.
07-02-2007 04:04 PM
Hi Shikamaru,
Here is the command,
Switch> (enable) sh port 3/1
Check this link
http://www.cisco.com/warp/public/473/53.shtml#Show_Port_for_CatOS_and_Show_Interfaces_
Please rate if that helps !
Regards,
`JG
07-02-2007 10:06 PM
Hi
To view the mac address table in CatOS
"sh cam dynamic"
You can also put in specific ports, do a
"sh cam ?"
HTH
Jon
07-03-2007 05:30 AM
Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.
The command is show arp.
07-02-2007 04:04 PM
Hi Shikamaru,
Here is the command,
Switch> (enable) sh port 3/1
Check this link
http://www.cisco.com/warp/public/473/53.shtml#Show_Port_for_CatOS_and_Show_Interfaces_
Please rate if that helps !
Regards,
`JG
07-02-2007 05:52 PM
Is there a way to see the MAC address table and ARP table in CatOS? I found a command that looks like it should give me the information (show port x/y), but it doesn't have any MAC addresses in it. I'd just like to know what IP addresses are connected to each interface.
-Shikamaru
07-02-2007 10:06 PM
Hi
To view the mac address table in CatOS
"sh cam dynamic"
You can also put in specific ports, do a
"sh cam ?"
HTH
Jon
07-03-2007 04:43 AM
How do you view the arp table in CatOS?
-Shikamaru
07-03-2007 05:30 AM
Since CatOS only functions at Layer2, you will only be able to see arp entries from the VLAN the management interface (sc0) is part of.
The command is show arp.
07-03-2007 07:12 AM
Thank you all for your help, you have been very helpful.
-Shikamaru
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide