I have bought a Cisco ASA 5510 firewall and am trying to use ASDM to configure it. After putting the firewall on I put the url https://192.168.1.1 the web page asks for the username and password. The instructions on the cisco web site says to leave both blank and click ok but it does n ot accept. How to reset this please.
For access to ASDM, here are the primary commands you need on ASA-
1) Set the ASDM image.
Assuming that you have asdm image file on disk of ASA saved as asdm.bin, you need to configure this commands-
asdm image disk0:/asdm.bin
2) Enable HTTP server-
http server enable
3) Allow hosts to connect to HTTP server-
http 0 0 inside
(to allow everyone on inside interface)
http 0 0 outside
(to allow everyone on outside interface)
By default, for user authentication, leave username field blank and enter your enable password. If you have not set any enable password yet, you may leave the password field blank too.
To set the enable password, you can use following command-
Hope this helps.