07-04-2007 02:26 AM - edited 03-05-2019 05:07 PM
I have two Cat 6506 with 2 1000Basex Gbic blades each in slots 2 & 3. Can you form an Etherchannel group with ports on different blades i.e. ports 2/16 & 3/16?
Running CatOS 8.3(3).
Solved! Go to Solution.
07-04-2007 02:57 AM
07-04-2007 03:02 AM
07-04-2007 02:29 AM
Hi
As long as the ports are of same type u can form the ether-channel with ports on different blades within the same chassis.
Thanks
Mahmood
07-04-2007 02:35 AM
Mahmood
Thank for that. the config would be -
set port channel 2/16 3/16 on? (Both switches).
Regards John
07-04-2007 02:57 AM
Hi John
Yes that is the right command for CatOS.
Jon
07-04-2007 03:02 AM
Hi
As Jon said the commands are correct.
Thanks
Mahmood
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: