snmp enable traps slb ft

Unanswered Question
Jul 4th, 2007

I trying to enable snmp traps on the CSM-S in order to get notification through HP Openview Network Node Manager that a 'fault tolerant' event has taken place. I am running 2.1(5) code.

I found the command reference for the CSMS 2.x code:

http://www.cisco.com/en/US/customer/docs/interfaces_modules/services_modules/csms/2.1.1/command/reference/s.html#wp1057213

There is a reference to the command: snmp enable traps slb ft

This is supposed to send an SNMP trap when the CSM transitions from standby to active after detecting a failure in its fault tolerant peer.

This example shows how to enable fault tolerant traps:

Cat6k-2(config-module-csm)# snmp enable traps slb ft

This command is not available in CSM configuration mode. In fact, there are no snmp commands at all in the CSM config mode.

Do I have to enable something globally on the 6500 first?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion