07-04-2007 02:44 PM - edited 03-05-2019 05:08 PM
I get a LOOPBACK error message on my 2950 switch which disables the port. What should I check for ? I have no idea where to start. Whats causing this?
07-04-2007 06:07 PM
Can you please post the exact error and also the output from typing
show interfaces status err-disabled
07-04-2007 07:43 PM
There was a bug filed but it was junked, because it is mostly caused by a STP loop or bad cabling. The following bug more details on this
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCea46385
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750smg/msg_desc.htm#wp98430
You might also want to consider err-disable recovery. You can enable it using
2950-A#conf t
Enter configuration commands, one per line. End with CNTL/Z.
2950-A(config)#errdisable recovery cause loopback
HTH, rate if it does
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: