ASA 5520 Firewall - Cisco Community

544

Views

0

Helpful

6

Replies

I need to remove one NAT which is there, through GUI it wont allow my saying some security rule warning. i also tried to disable security rule and tried but still couldnt do it.

now i was thinking to remove from command line.

the NAT is shown below

static (Inside,Outside) XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX netmask 255.255.255.255

The ip address for Inside, Outside is the same so i was trying to remove it. could any one tell me how can i remove this line from command line??

waiting...

6 Replies 6

hello,

on the prompt write

(config)# no static (Inside,Outside) XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX netmask 255.255.255.255

hth, please rate it

no static (Inside,Outside) 62.215.215.215 62.215.215.215 netmask 255.255.255.255

^ clear global 62.215.215.215 Local 62.215.215.215

ERROR: % Invalid input detected at '^' marker.

I GET THIS ERROR MESSAGE! PLEASE HELP ON THIS!

clear xlate global 62.215.215.215

tried this as well, but

didnt work, doesnt give any error... but when i say

sh xlate

the entry is still there!

do i need to remove NAT before that?

any help on this please?

hello,

do the above as suggested and reload your firewall.

hth, please rate it

doesnt work!! is there any thing else linked with this which i need to delete before i run this command?? i tried to delete xlate before i delete the nat! doesnt work!

Learn, share, save

Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.

New here? Get started with these tips. How to use Community New member guide

Log in to Community

Review Cisco Networking products for a $25 gift card