07-05-2007 02:34 AM - edited 03-05-2019 05:08 PM
hi
is there any way to give priority to a specific switchport over the other port into a 2950 switch?
thanks
07-05-2007 04:44 AM
STP priority ?
Sure, under the interface
spanning-tree port-priority [priority]
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2960/12225see/scg/swstp.htm#wp1020470
07-05-2007 07:19 AM
i was thinking to give priority to a specific machine which running a special program connecting in that port....does spanning tree priority covers this need?
07-05-2007 09:39 AM
No, STP handles loops in the network. If you are looking for Quality of Service, the 2950 switch is very limited on that aspect.
It's the source and destination device on the same switch ?
07-05-2007 10:58 AM
hi
no its located in another switch....
07-05-2007 12:49 PM
Please familiarize with QoS on 2950. Good Luck !
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12122ea7/scg/swqos.htm
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: