Edison Ortiz Fri, 07/06/2007 - 04:20
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Please post your 'show version' from this device .


Can you also try the command 'wr mem' and see if it works ?

mikntwd49508 Fri, 07/06/2007 - 04:25
User Badges:

Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(4)XC4, RELEASE SOFTWARE (fc1)

Synched to technology version 12.4(5.13)T

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Mon 24-Jul-06 18:33 by ealyon


ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)

ROM: Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(4)XC4, RELEASE SOFTWARE (fc1)


DPI-CME-2811 uptime is 16 weeks, 1 day, 23 hours, 31 minutes

System returned to ROM by Reload Command

System restarted at 08:53:53 EDT Wed Mar 14 2007

System image file is "flash:c2800nm-advipservicesk9-mz.124-4.XC4.bin"



Edison Ortiz Fri, 07/06/2007 - 04:31
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

That's not a complete 'show version'. I was looking for the current config-register setting.


Please repost the entire show version.


Did you try 'wr mem' as suggested ?


Can you also post the output from typing


'show priv'.

guruprasadr Fri, 07/06/2007 - 04:37
User Badges:
  • Gold, 750 points or more

HI,


Its better to capture & attach the complete output of "show tech-support" for full - analysis.


Best Regards,


Guru Prasad R

mikntwd49508 Fri, 07/06/2007 - 04:48
User Badges:

WR MEM


DPI-CME-2811#wr mem

Building configuration...

Compressed configuration from 29043 bytes to 13778 bytes[OK]


Show Version


Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(4)XC4, RELEASE SOFTWARE (fc1)

Synched to technology version 12.4(5.13)T

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by Cisco Systems, Inc.

Compiled Mon 24-Jul-06 18:33 by ealyon


ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)

ROM: Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(4)XC4, RELEASE SOFTWARE (fc1)


DPI-CME-2811 uptime is 16 weeks, 1 day, 23 hours, 52 minutes

System returned to ROM by Reload Command

System restarted at 08:53:53 EDT Wed Mar 14 2007

System image file is "flash:c2800nm-advipservicesk9-mz.124-4.XC4.bin"



This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.


A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html


If you require further assistance please contact us by sending email to

[email protected].


Cisco 2811 (revision 53.51) with 247808K/14336K bytes of memory.

Processor board ID FTX0908A12N

2 FastEthernet interfaces

25 Serial interfaces

1 terminal line

2 Channelized T1/PRI ports

2 Virtual Private Network (VPN) Modules

2 Voice FXO interfaces

1 cisco service engine(s)

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62592K bytes of ATA CompactFlash (Read/Write)


Configuration register is 0x2102


DPI-CME-2811#



SHOW PRIV


Current privilege level is 15

Edison Ortiz Fri, 07/06/2007 - 05:36
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Gosh, I can't believe I overlooked the obvious.


The command is


copy running-config startup-config

not

copy running-configuration startup-configuration


running-configuration will be treated as a file name.



Actions

This Discussion