07-06-2007 08:43 AM - edited 03-14-2019 10:26 PM
What are the inital commands to login to a VG200 from the command prompt?
07-06-2007 09:18 AM
Hi Bill,
Have a look at this doc;
Cisco VG224 Voice Gateway Software Configuration Guide
Configuring with the Command-Line Interface
Hope this helps!
Rob
07-06-2007 09:22 AM
What I need to know is from the C:\Documents and Settings\lamb> what do I type in first to get to the gateway? What you sent me does not show this.
07-06-2007 01:54 PM
The answer is telnet ip address of gateway
07-06-2007 09:26 AM
What I need to know is from the C:\Documents and Settings\lamb> what do I type in first to get to the gateway? What you sent me does not show this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: