Wireless controller issues

Unanswered Question
Jul 7th, 2007

I have just deployed a 4402 wireless controller and updated autonomous 1231 aironets to lightweight mode. All works ok.

I create an interface on a vlan and added IP addresses etc.

Whenever i attempt to associate a WLAN with the interface the only interface available is Management

Another problem is if I create a interface and dont enable Dynamic AP management I loose access to the controller and have to remove the interface via the service port.

Any ideas would be welcome

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ericgarnel Mon, 07/09/2007 - 10:11

On the WLC, is the newly created interface enabled?

You should enable dynamic ap management on the management interface or other interface, not a dynamically created interface for client traffic.

Is the port from the switch to WLC in trunk mode?

jwadleigh Fri, 08/24/2007 - 10:44

Confirm the following:

1.) Management and AP-Manager interface are on a single VLAN.

2.) Dynamic Interface is on a different VLAN and enabled.

3.) Both VLAN's exist on the connected switch.

4.) The connected switch port is configured as a dot1q trunk including both VLAN's listed above.


This Discussion