H.323 Plar to Unity AA problem, need help

Unanswered Question
Jul 7th, 2007
User Badges:

Gateway: Cisco 2811 with newest IOS

CallManager: Ver 5.1

Unity Connection: Ver 1.2


All incoming calls would be going to Unity AA first. During business-hour calls will be transfered directly from the AA to the receptionist, if receptionist is not available, a Working-Hour-AA will handle the call. As soon as it hits 5:00PM then it will not go to the receptionist but will play the After-Hour-AA call handler. I have the connection plar working to the AA.

The configuration works well during business-hour.


After-Hour-AA will allow caller dial the extension, so I need the configuration:

dtmf-relay h245-alphanumeric

on the VoIP dial-peer.

When I tested to dail the main number(main number-> gateway-> plar 500[AA Number]), I hear the Unity prompt "I cannot recognize this invalid entry" instead of the After-Houre-AA, but the caller can still dial an extension and the call can be established successfully.

If I remove the configuration:

dtmf-relay h245-alphanumeric

from VoIP dial-peer, the call can be transfered to After-Hour-AA, but Unity cannot receive the extension caller dialed(it is true).

Related Configuration:

controller T1 0/0/1

framing sf

linecode b8zs

ds0-group 0 timeslots 1-2 type e&m-wink-start

ds0-group 1 timeslots 3-24 type e&m-wink-start

interface GigabitEthernet0/1

ip address

duplex full

speed auto

media-type rj45

no keepalive

h323-gateway voip interface

h323-gateway voip bind srcaddr

voice-port 0/0/1:0

connection plar 500


voice-port 0/0/1:1

connection plar 500

dial-peer voice 100 voip

preference 1

destination-pattern 500

session target ipv4:

incoming called-number 9.T

dtmf-relay h245-alphanumeric

codec g711ulaw bytes 80

no vad


dial-peer voice 1 pots

destination-pattern 9.T


port 0/0/1:0


dial-peer voice 2 pots

destination-pattern 9.T


port 0/0/1:1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion