Ip Servce Image for 3560 switch that are used for L3/L2

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Amit Singh Mon, 07/09/2007 - 00:32
User Badges:
  • Cisco Employee,

No, it doesnot depend on the IP services image. Ip services only provides the following capabilties:


Dynamic Routing Protocols:


-Open Shortest Path First (OSPF)


?Enhanced IGRP (EIGRP)


?Border Gateway Protocol Version 4 (BGPv4)


Policy-based Routing (PBR)


?Allows superior control by enabling flow redirection regardless of the routing protocol configured


Protocol-Independent Multicast (PIM)


?For IP multicast routing within a network that enables the network to receive the multicast feed requested and for switches not participating in the multicast to be pruned-support for PIM sparse mode (PIM-SM), PIM dense mode (PIM-DM), and PIM sparse-dense mode


Distance Vector Multicast Routing Protocol (DVMRP)


?Tunneling for interconnecting two multicast-enabled networks across non-multicast networks


Private VLAN (PVLAN)


?Provides the ability to restrict communications between hosts at layer 2 through the use of primary and secondary VLANs.


It actually depends on the IDB limit on the IOS.


http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_tech_note09186a0080094322.shtml#max_no_vlans


http://www.cisco.com/en/US/products/hw/switches/ps5023/products_qanda_item09186a00801b0971.shtml


HTH,Please rate if it does.


-amit singh


Actions

This Discussion