07-08-2007 11:52 PM - edited 03-10-2019 03:15 PM
Hi,
i am just wondering that a network device is sending his requests to the acs appliance with another ip than the configured ip that is configured with the "ip tacacs source-interface" command.
The problem occured first when i was searching a network device in the TACACS+ Administration Report. I expected to filter the Loopback-IP configured with the "ip tacacs source-interface" command. But the network device (cisco CISCO7604) was answering with an ip configured on a VLAN-IP.
Does anybody have an idea about this behaviour?
Thanks
Torsten Waibel
07-09-2007 03:57 AM
Check if this applies,
CSCdv62649 : ip tacacs source-interface not working
Regards,
Prem
07-09-2007 06:11 AM
Hi,
this bug describes nearly our problem.
in our case the aaa authentication is still working. we only have problems with the identification of the NAS inside the TACACS+ Administration Report.
As we have only wildcards and no names for our network device groups we need to filter now for an ip which is configured on a routed interface instead of the tacacs source-interface.
We have this problem on Cisco 7600 Routers running ios 122-18.SXF5. So it seems that the bug is still not fixed.
Regards
Torsten Waibel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: