07-09-2007 04:24 AM - edited 03-03-2019 05:46 PM
Hello. I need help.
I have a cluster running windows 2003 server which are in a Catalyst 3560G and belong to VLAN named "servers".The Network Load Balancing cluster hosts are connected to the Ethernet switch (3560G)
which is connected to a centralized Ethernet Routing Switch (Catalyst 4510R)using a single uplink port
trunk. Clients are connected to Catalyst 4510R directly and others layer 2 swichtes Catalyst. I want to deploy Microsoft Network Load Balancing using mode Multicast. How can I do it?. What configuration have I to do in the switches (Catalyst 4510R and 3560G)?.
Thanks
07-10-2007 02:47 PM
I just setup an MS NLB in unicast mode and I didn't have to change a thing.
Really I would just make sure that there aren't duplicate ARP entries for the cluster IP address. Only have the new multicast ARP entry in the ARP table for that specific IP address.
Bryan
08-20-2007 06:57 AM
hello Bryan, it's possible to setup MS NLB whith C2960 and C2970 cisco switch's
thank's
08-20-2007 07:08 AM
Hi,
I always use the attached document for any multicast clustering of firewalls. Might be able to help you.
Also, this link may help you http://technet2.microsoft.com/windowsserver/en/library/12fb5106-d068-4a03-9864-cf5da9e31e851033.mspx?mfr=true
Regards,
Dandy
08-20-2007 09:56 AM
Ok thank's
i will try.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide