Hi,
I have aaa auth and snmp / syslog running on my Cisco3640 for dial in users. The users are authenticaticated against a Win2k box and the resulting connection info is sent to my syslog/snmp server.
The problem is the info is not very good. It basically only shows if the port has come up and when it goes down again ( i.e. Async 85 up ). I would like the syslog / snmp server to show the username and if possible the assigned dhcp address for all dial in users.
Is this possible ?
I have looked under snmp-server traps and accounting and cant seem to see the correct command set.
Any thoughts ?
cheers
Richard