Cisco Works Netconfig

Unanswered Question
Jul 9th, 2007

Netconfig configured with a Task to deploy Access-list config out to Routers and Switches to 190 devices returns a fail to 35 of the 190 devices. The Failure message is detailed below. Applying the config manually to the device works.

Failure message : Command(s) failed on the device TFTP: Failed on the device. Insufficient no. of interactive responses(or timeout) for command: access-list 1 remark ?SNMP Read-Only Hosts?.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
David Stanford Tue, 07/10/2007 - 07:33

How are you doing carriage returns in your interactive commands?

Can you select one of the failing devices and attempt the job again while performing a packet capture?

You can also turn on debugs for netconfig.

Actions

This Discussion