07-10-2007 03:01 PM - edited 03-03-2019 05:47 PM
I have a 2811 running 12.4(11XJ) Adv Enterprise and I cannot remote static nat entries. I have tried a reboot, taking off the nat inside/outside interface commands. Any ideas. It is bizarre.
Solved! Go to Solution.
07-10-2007 03:22 PM
Likely bug CSCsg84883.
Try repeating the "no ip nat .." many times in rapid succession, a colleague of mine succeeded this way.
If still there, the only option is to save config to a file, edit out the nat command, copy file back to nvram (conf over), reboot.
hope this helps, please rate post if it does
07-10-2007 03:22 PM
Likely bug CSCsg84883.
Try repeating the "no ip nat .." many times in rapid succession, a colleague of mine succeeded this way.
If still there, the only option is to save config to a file, edit out the nat command, copy file back to nvram (conf over), reboot.
hope this helps, please rate post if it does
07-11-2007 05:52 AM
Entering it in many times got the job done. Thank you very much.
07-11-2007 06:28 AM
Good to know it worked, perhaps cisco should update the bug with this brutal workaround info.
Thanks for the nice rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide