Input errors

Unanswered Question
Jul 11th, 2007


I am gettin input errors, CRC errors when I connect my switch to a router.

Attached is the "show int" of the switch

Could anyone advise?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Amit Singh Wed, 07/11/2007 - 01:07

I see that both the sides are hardcoded to Speed 100 and duplex full. What happens if you auto-configure the speed and duplex on both the sides. I would suggest to set both of them as auto-auto on both the sides and update us on that. Also try replacing the cable connecting the two device with a known good one.

-amit singh

rootadmin Wed, 07/11/2007 - 01:26


I have tried changing the cables. The only difference I saw on the router that there is an encapsulation dot1q configured. Will these cause a problem?


Amit Singh Wed, 07/11/2007 - 01:58

The switchport connected to the router (with dot1q encapsulation ) should be configured as the trunk link. I see that your switchport is configured as an accessport.

Please paste the config from your router.

-amit singh


This Discussion