concerning configuration when upgrading modules

Answered Question
Jul 11th, 2007
User Badges:

When you upgrade to new switch modules does the configuration stay or do you need to reconfigure the new module?

Correct Answer by Jon Marshall about 10 years 2 weeks ago

Hi


Then i suspect not as the interfaces on the module you currently have will be fa0/1, fa0/2 etc. whereas the new interfaces in the config will be gi0/1, gi0/2 etc.


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jon Marshall Wed, 07/11/2007 - 09:07
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


Could you send a few more details ie.


switch type

module being replaced

new module


Jon

MZydorczyk2 Wed, 07/11/2007 - 09:12
User Badges:

I am replacing 10/100 modules in a catalyst 4506 switch with ws-x4548-gb-rj45 10/100/1000 modules.



Correct Answer
Jon Marshall Wed, 07/11/2007 - 09:21
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


Then i suspect not as the interfaces on the module you currently have will be fa0/1, fa0/2 etc. whereas the new interfaces in the config will be gi0/1, gi0/2 etc.


Jon

MZydorczyk2 Wed, 07/11/2007 - 09:24
User Badges:

Thanks. Yeah I pretty much figured that was the most reasonable, just wanted to be sure since I never did it.

Actions

This Discussion