07-11-2007 08:32 AM - edited 03-05-2019 05:14 PM
When you upgrade to new switch modules does the configuration stay or do you need to reconfigure the new module?
Solved! Go to Solution.
07-11-2007 09:21 AM
Hi
Then i suspect not as the interfaces on the module you currently have will be fa0/1, fa0/2 etc. whereas the new interfaces in the config will be gi0/1, gi0/2 etc.
Jon
07-11-2007 09:07 AM
Hi
Could you send a few more details ie.
switch type
module being replaced
new module
Jon
07-11-2007 09:12 AM
I am replacing 10/100 modules in a catalyst 4506 switch with ws-x4548-gb-rj45 10/100/1000 modules.
07-11-2007 09:21 AM
Hi
Then i suspect not as the interfaces on the module you currently have will be fa0/1, fa0/2 etc. whereas the new interfaces in the config will be gi0/1, gi0/2 etc.
Jon
07-11-2007 09:24 AM
Thanks. Yeah I pretty much figured that was the most reasonable, just wanted to be sure since I never did it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: