NAT port forwarding

Unanswered Question
Jul 11th, 2007
User Badges:

I have recently purchased a Cisco 871 router. In the GUI from the installed software, I have been able to configure which ports are forwarded to a specified IP address within my local area network.

This seems to output a configuration line like this:

ip nat inside source static tcp 1000 interface Dialer0 1000

However, I can only do this one port at a time. Is there a function or command that I can use to specify a range of ports? For example, I would like to forward tcp ports 1000-2300 to the IP address

Any help would be appreciated.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
drolemc Wed, 07/18/2007 - 06:33
User Badges:
  • Silver, 250 points or more

I think in order to support the use of non-standard FTP port numbers, you must use the ip nat service command. This is a sample syntax: router-6(config)#ip nat service list 10 ftp tcp port 2021.

For more information please click following URL:


This Discussion