voice port configuration

Unanswered Question
Jul 11th, 2007
User Badges:

Below is the partial configuration.


My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This configuration is not working, needs modification. Pls help in this



dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1


dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1



dial-peer voice 210 pots

preference 8

destination-pattern 0[1-4,6-9][0-9]?

no digit-strip

direct-inward-dial

port 2/1/0

!

dial-peer voice 211 pots

preference 8

destination-pattern 00[1-4,6-9][0-9]?

no digit-strip

port 2/1/1

!

dial-peer voice 300 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/0

!

dial-peer voice 301 pots

preference 8

destination-pattern [1-4,6-9][0-9]?

no digit-strip

port 3/0/1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Thu, 07/12/2007 - 00:23
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi,


suggest that you configure all the ports that are connected to PSTN, in trunk-group. This will allow you to configure a single DP pots for each destinan-pattern, with said trunk-group as destination instead of port.


Once you do this the configuration is much reduced and so chances of error.


If still problems after that,please postif "IP Telephony" forum.


Hope this helps, pleaserate post if it does!




vinay_verma80 Sun, 07/15/2007 - 15:21
User Badges:

hi


u are geting this result because of wrong conf


put a dial-peer with destination pattern with 0 and atatch it port 2/1/x (also put preference 9 on the dial peer)


any for good sake use diffrent preferences on each dail-peer



plz rate this if u like


regards

Actions

This Discussion