07-11-2007 08:53 PM - edited 03-14-2019 10:30 PM
Below is the partial configuration.
My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This configuration is not working, needs modification. Pls help in this
dial-peer voice 210 pots
preference 8
destination-pattern 0[1-4,6-9][0-9]?
no digit-strip
direct-inward-dial
port 2/1/0
!
dial-peer voice 211 pots
preference 8
destination-pattern 00[1-4,6-9][0-9]?
no digit-strip
port 2/1/1
!
dial-peer voice 300 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/0
!
dial-peer voice 301 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/1
dial-peer voice 210 pots
preference 8
destination-pattern 0[1-4,6-9][0-9]?
no digit-strip
direct-inward-dial
port 2/1/0
!
dial-peer voice 211 pots
preference 8
destination-pattern 00[1-4,6-9][0-9]?
no digit-strip
port 2/1/1
!
dial-peer voice 300 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/0
!
dial-peer voice 301 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/1
dial-peer voice 210 pots
preference 8
destination-pattern 0[1-4,6-9][0-9]?
no digit-strip
direct-inward-dial
port 2/1/0
!
dial-peer voice 211 pots
preference 8
destination-pattern 00[1-4,6-9][0-9]?
no digit-strip
port 2/1/1
!
dial-peer voice 300 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/0
!
dial-peer voice 301 pots
preference 8
destination-pattern [1-4,6-9][0-9]?
no digit-strip
port 3/0/1
07-18-2007 09:09 AM
Play with preference command, if you give low preference value the call will routed via that port, higher the preference value at port for back-up route.
07-18-2007 09:26 AM
You should use trunkgroups (configure under voice-port and in place of port unde DP). That way you will:
- have single DP eliminating redundant configuration
- be able to use multiple trunk-group for a same DP, if desired.
- define precedence for individual lines with trunk-group
- define an hunt-scheme on how to use the lines
- pull statistics on trunkgroup usage and it's individual lines.
Hope this helps, please rate post if it does!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: