Configuring Channelized T1/E1 VWIC - Urgent Help Needed

Answered Question
Jul 12th, 2007

I installed a new VWIC2-1MFT-T1/E1 card in my cisco 3825 router, and the router does see it, but I am unable to configure the "controller T1".

2 Gigabit Ethernet interfaces

60 Serial interfaces

8 Channelized T1/PRI ports

1 Channelized (E1 or T1)/PRI port

The new card is in slot 0/3, but I keep getting the error below:

RS_3825(config)#controller t1 0/3/0

^

% Invalid input detected at '^' marker.

Please help.

Thanks.

hieu

Correct Answer by chrihussey about 9 years 7 months ago

Try the global command:

card type t1 0 3

You need to identify to the router if your using it as a T1 or E1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
chrihussey Thu, 07/12/2007 - 07:55

Try the global command:

card type t1 0 3

You need to identify to the router if your using it as a T1 or E1

Hieu Cao Fri, 07/13/2007 - 08:25

Hello Chris,

Thank you for your help. I did just that and it worked great.

hieu

Actions

This Discussion