ATA 186 Factory reset protection

Unanswered Question
Jul 12th, 2007

How to configure OpFlags bits 28-31 with a value of 6 via IVR?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dsweeny Wed, 07/18/2007 - 13:55

Disconnect the ethernet cable. Plug phone to phone1 jack.

Step 1 Lift the handset and press the Function button located on top of the Cisco ATA 186.

Step 2 Enter the IVR menu number for the parameter that you want to configure or the

command that you want to execute; then, press the pound key(#).

IStep 3 Follow the applicable prompts.

Step 4 When you have finished, make sure you press 3 to save your changes.

Step 5 Hang up the telephone. The Cisco ATA 186 resets.he function button will fast-blink when the

reset is complete.

reboot (sometimes required)

s.lupogan Wed, 07/18/2007 - 17:53


Thank you but the question is not how to use the IVR.

The question is HOW TO CONFIGURE OpFlags BITS 28-31 WITH A VALUE OF 6 VIA IVR?

twissam Mon, 07/23/2007 - 10:35

check the ATA admin guide.

i did not do it personally but it is the voice menu "323"


This Discussion