07-12-2007 06:51 PM - edited 03-14-2019 10:31 PM
How to configure OpFlags bits 28-31 with a value of 6 via IVR?
07-18-2007 01:55 PM
Disconnect the ethernet cable. Plug phone to phone1 jack.
Step 1 Lift the handset and press the Function button located on top of the Cisco ATA 186.
Step 2 Enter the IVR menu number for the parameter that you want to configure or the
command that you want to execute; then, press the pound key(#).
IStep 3 Follow the applicable prompts.
Step 4 When you have finished, make sure you press 3 to save your changes.
Step 5 Hang up the telephone. The Cisco ATA 186 resets.he function button will fast-blink when the
reset is complete.
reboot (sometimes required)
http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/atarn/atarn16.htm#89135
07-18-2007 05:53 PM
Hello,
Thank you but the question is not how to use the IVR.
The question is HOW TO CONFIGURE OpFlags BITS 28-31 WITH A VALUE OF 6 VIA IVR?
07-23-2007 10:35 AM
check the ATA admin guide.
i did not do it personally but it is the voice menu "323"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: