paolo bevilacqua Fri, 07/13/2007 - 01:28
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No, it does not.You will need H323 on the GW for E1-R2.


Hope this helps, please rate post if it does!

mike.lo Fri, 07/13/2007 - 03:05
User Badges:

so, where can i get the configuration in h323 connection?

paolo bevilacqua Fri, 07/13/2007 - 03:08
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi,


config for E1 R2 is very peculiar to country and telco. Where are you located ? In the forum there are posts with examples for telmex and few others. For an introductory discussion, see:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800942f2.shtml


Advice: if you have _any_ chance to have the circuit provision as PRI instead, do that. E1 R2 is very challenging to configure and troubleshoot if something goes wrong.


mike.lo Fri, 07/13/2007 - 03:37
User Badges:

tks for support, the place we deploy is Manila. we try to ask them to change into E1 PRI, but i know that DDI range can't keep. so it is difficult.

besides, is it possible that mgcp can support it in later ccm version, say 6.0?

paolo bevilacqua Fri, 07/13/2007 - 03:44
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

hi,


CCM 6.0 is out and doesn't support E1 R2. I think the reason is that it is so complicated, that only the router can do it.

Actions

This Discussion