Channelised E1 support

Unanswered Question
Jul 12th, 2007

Hi,

I have a Cisco 2821 Router which support one NM module and where I have insered two port Channelised E1 Card (NM-2CE1T1-PRI). But now I need to terminate one more E1 ( Channelised) in this router.

Does VWIC2-2MFT-T1/E1 or VWIC2-2MFT-G703 card supports channelised E1 ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Fri, 07/13/2007 - 01:18

Yes, it does. VWIC2-2MFT-G703 is needed only for unframed E1(and much more expensive).

Hope this helps, please rate post if it does!

Wilson Samuel Fri, 07/13/2007 - 05:17

Hi,

This supports not only E1/Channelized E1 but also T1/ Fractional T1

Regards,

Wilson Samuel

Actions

This Discussion