07-12-2007 10:26 PM - edited 03-03-2019 05:51 PM
Hi,
I have a Cisco 2821 Router which support one NM module and where I have insered two port Channelised E1 Card (NM-2CE1T1-PRI). But now I need to terminate one more E1 ( Channelised) in this router.
Does VWIC2-2MFT-T1/E1 or VWIC2-2MFT-G703 card supports channelised E1 ?
07-13-2007 01:18 AM
Yes, it does. VWIC2-2MFT-G703 is needed only for unframed E1(and much more expensive).
Hope this helps, please rate post if it does!
07-13-2007 05:17 AM
Hi,
This supports not only E1/Channelized E1 but also T1/ Fractional T1
Regards,
Wilson Samuel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide