07-13-2007 07:19 AM - edited 03-05-2019 05:17 PM
Hi there,
Guys, I dont have the hardware to hard, but does anyone have the default config for these two port queueing types?
Also, in CatOS, you can do a wr term all and get the defaults, can you do this in IOS?
Many thx
Ken
07-13-2007 07:46 AM
Hi,
The defaults are all in the config guide, here:
In IOS you can't get the defaults with a show command, unfortunately you need to look them up..
HTH
Andrew.
07-13-2007 07:53 AM
thats a bit of a pain :(
just wondering if anyone had a catOS switch and could do a write term all to get the defaults, but if no joy, I will work though the doc and work them out.
I am just comparing what Cisco best practises are ie,
set qos txq-ratio 1p7q8t 5 25 10 10 10 5 5 30
set qos wrr 1p7q8t 5 25 20 20 20 5 5
set qos wred 1p7q8t tx queue 1 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 2 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 3 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 4 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 5 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 6 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos wred 1p7q8t tx queue 7 80:100 100:100 100:100 100:100 100:100 100:100 100:100 100:100
set qos map 1p7q8t tx 1 1 cos 1
set qos map 1p7q8t tx 2 1 cos 0
set qos map 1p7q8t tx 3 1 cos 4
set qos map 1p7q8t tx 4 1 cos 2
set qos map 1p7q8t tx 5 1 cos 3
set qos map 1p7q8t tx 6 1 cos 6
set qos map 1p7q8t tx 7 1 cos 7
set qos map 1p7q8t tx 8 cos 5
set qos map 1p7q8t tx 6 1 cos 6
set qos map 1p7q8t tx 7 1 cos 7
set qos map 1p7q8t tx 8 cos 5
and what the actual defaults are
Many thx indeed fella,
Ken
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: