Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
379
Views
5
Helpful
2
Replies

A hardware question on NVRAM.

rmundy
Level 1
Level 1

‎07-13-2007 07:50 AM - edited ‎03-05-2019 05:17 PM

Where is NVRAM on a switch? Is it just an EEPROM on the device or is it really FLASH? Just trying to figure it out. Had a router power supply go bad and replaced the device via SmartNet. I've moved the RAM and FLASH over to the replacement, but the startup-config isn't there.

Labels:
0 Helpful
2 Replies 2

Collin Clark
VIP Alumni
VIP Alumni

‎07-13-2007 11:02 AM

I'm pretty sure it's hardwired to the system board. Copy and pasting will get you most of the config though.

HTH and please rate.

rmundy
Level 1
Level 1
In response to Collin Clark

‎07-13-2007 11:56 AM

That's what I figured, but wanted confirmation. Thanks.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card