Solved: Disabling 3750 interface snmp traps

williamka · ‎07-13-2007

I constantly receive trap information on 3750 switch for interface up/down and would like to disable this notification. Is there some way to disable the notifications for workstation interfaces and keep trunk interfaces active? Thank you for any assistance

sundar.palaniappan · ‎07-13-2007

Configure 'no snmp trap link-status' on ports for which you don't want to receive link status alarms.

SW1-3550(config)#int f0/1

SW1-3550(config-if)#no snmp trap ?

link-status Allow SNMP LINKUP and LINKDOWN traps

mac-notification MAC Address notification for the interface

SW1-3550(config-if)#no snmp trap link-status

SW1-3550(config-if)#do show run int f0/1

Building configuration...

Current configuration : 171 bytes

!

interface FastEthernet0/1

switchport mode access

no snmp trap link-status

HTH

Sundar

View solution in original post

Collin Clark · ‎07-13-2007

Do you want to disable all traps or just interface up/down? Can you post a "show run | inc snmp" and remove the community?

williamka · ‎07-13-2007

I want to disable the fastethernet interfaces for up/down and if possible keep the gig trunk ports.

sh run | inc snmp

snmp-server community xxxxxxx RO 66

snmp-server community xxxxxxx RW 66

snmp-server location Somewhere

snmp-server contact Someplace at x12345

I included ACL 66 below....

access-list 66 permit 10.20.50.38

access-list 66 permit 10.20.20.120

access-list 66 permit 10.20.20.121

access-list 66 permit 10.20.50.22

access-list 66 permit 10.20.23.0 0.0.0.255

access-list 66 permit 10.10.21.0 0.0.0.255

access-list 66 permit 10.30.21.0 0.0.0.255

access-list 66 permit 10.24.1.0 0.0.0.255

access-list 66 deny any

sundar.palaniappan · ‎07-13-2007