CRS Editor - debug sessions showing in reporting engine tasks

Unanswered Question
Jul 13th, 2007

I have been running some debug sessions in the CRS Editor. I have noticed that the Real Time reporting for engine tasks has my sessions listed, even though I let the script run to the end. Why would this occur? And how can I stop those tasks?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Gergely Szabo Mon, 07/16/2007 - 02:42


you mean the sessions remain active for 3 minutes and so, in state SESSION_IDLE?

If yes, this is something I did not get an answer from Cisco either, sometimes those sessions just remain there until they got garbage collected. I was not able to do anything about it either...


joannemarie Mon, 07/16/2007 - 05:58

They were actually staying in for a couple hours at my last check. I logged in to the CRS server and they are now gone.


This Discussion