07-14-2007 07:12 AM - edited 03-05-2019 05:17 PM
Why is it that I cannot use the show interfaces trunk command on a c2924xl en switch.
The switch is running c2900xl-c3h2s-mz.120-5.WC10.bin IOS.
Solved! Go to Solution.
07-14-2007 08:02 AM
07-14-2007 08:02 AM
The command is:
show interface interface-id switchport
07-14-2007 09:03 AM
07-14-2007 01:31 PM
thank you for your help.
07-14-2007 12:01 PM
Because that switch is so old it does not use the same commands as newer ios switches.
07-14-2007 01:29 PM
I know that they are supper old but that is all that I can aford to buy to get ready for CCNA.
07-14-2007 02:54 PM
Understood I am just telling you the reason , there are differences between that old 2924 and say a 2950 as far as commands go and you should keep that in mind if are studying for certs because I believe they base the tests on a 2950 or higher.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: