cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
512
Views
5
Helpful
6
Replies

Trunking

javier.moreno
Level 1
Level 1

Why is it that I cannot use the show interfaces trunk command on a c2924xl en switch.

The switch is running c2900xl-c3h2s-mz.120-5.WC10.bin IOS.

1 Accepted Solution

Accepted Solutions

Edison Ortiz
Hall of Fame
Hall of Fame

The command is:

show interface interface-id switchport

View solution in original post

6 Replies 6

Edison Ortiz
Hall of Fame
Hall of Fame

The command is:

show interface interface-id switchport

thank you for your help.

glen.grant
VIP Alumni
VIP Alumni

Because that switch is so old it does not use the same commands as newer ios switches.

I know that they are supper old but that is all that I can aford to buy to get ready for CCNA.

Understood I am just telling you the reason , there are differences between that old 2924 and say a 2950 as far as commands go and you should keep that in mind if are studying for certs because I believe they base the tests on a 2950 or higher.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card