cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
318
Views
0
Helpful
1
Replies

Dropped calls

sureshkrishnan
Level 1
Level 1

Hi,

While using the 7920 over the wireless network, what are the reasons for which a call can be dropped? There is a ring going, but when the call is picked the call gets dropped.

Regards

1 Reply 1

migilles
Cisco Employee
Cisco Employee

The CallManager can send a SCCP message to the phone to terminate a call.

The 7920 will not drop a call unless pressing endcall button.

Can even roam out of AP coverage for multiple minutes and can return where the call can be re-estabilished (assuming other side didn't hang up already).

So is this incoming call to the 7920?

Does it ring? If so, then once you select answer, the phone will sent what IP and UDP port to send RTP to. Once rx info about the other device, then may have to ARP if the address is not already known.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card