07-14-2007 10:19 PM - edited 03-03-2019 05:52 PM
HWIC is layer-II device i am using in 2811 i want to convert this to layer-III so i can assign ip address on ports. no Switchport cmd is also not working. i am trying to creat vlan but could not enter in vlan database. using 12.4 advance security IOS.
I want layer-III interafce for LAN?? please advice what 2811 supports in this module?? i tried using NM2FE2W but to no avail....its not compatible i think...yellow link blinks and then goes off......
please advise...
Thanks,
07-14-2007 11:11 PM
Friend,
If you want an additional ethernet module, you can use the HWIC-1FE (the min IOS required though is 12.4(11) XJ)
http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd80581fe6.html
HWIC-16ESW is also supported on the 2811 which gives you 16 ports and can be configured for VLAN interfaces
http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00802c6bb6.html
The 2811 also supports the NM-16ESW module
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a00801aca3e.html
Have a look at the 2800 data sheet for the supported modules for your needs
http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8016fa68.html
HTH, rate if it does
Narayan
07-15-2007 03:05 AM
Hi,
beside Narayn's good advice, there is no need to create use vlan database commands, just configure interface vlan X and assign the needed ports to it.
What does it mean the switchport command doesn't work? Please be more specific.
07-15-2007 04:10 PM
I created VLAN but interface status showing down. secondly i want to use that interface for GRE/IPSEC.
07-15-2007 05:08 PM
Config and show interface please ?
07-15-2007 08:17 PM
hi aziz,
Advanced security IOS i belive shudn't hinder you from entering VLAN Database.
Nevertheless, you can:
1. create a vlan using " int vlan x"
2. Assing the FE switch port using "switch port access vlan X"
3. Connect that switch port to a router
4. sh ip int brief, you can see the port is up as well the VLAN X.
Cheers!
07-15-2007 08:27 PM
IPSEC/GRE may have issue on HWIC port, as it have limited functionality.You may test it out.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: