07-14-2007 11:14 PM - edited 03-09-2019 06:23 PM
What is method for disabling NAT on FWSM and use ASDM. For high level to low level access and vice versa.
07-16-2007 01:31 PM
access-list extended NoNAT permit 192.168.1.0 255.255.255.0 10.10.10.0 255.255.255.0
nat (inside) 0 access-list NoNAT
This would disable NAT for traffic sourcing from 192.168.10/24 going to 10.10.10.0/24. The key is the 0 after (inside).
It's much easier to enable/disable NAT via CLI.
Here's a link that might help as well. http://cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091cb9.shtml
HTH and please rate.
07-17-2007 07:37 PM
I need the procedure to do it on ASDM and reducing lines on FWSM. Could any one explain on this?
07-16-2007 08:11 PM
What version of software are you running on the FWSM? I believe on version 3.1 you can disable nat control where you do not have to configure nat.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: