07-16-2007 12:38 AM - edited 03-03-2019 05:52 PM
Hi,
I have a 3640 router with a 2FE2W-V2 but this module is not recognize by the router, due to it I want to make a upgrade software but
my procedure is I connect a cross-cable from the fast ethernet to my pc, so have you an idea how I can make the upgrade without ethernet connection?
Thanks in advance.
Solved! Go to Solution.
07-16-2007 01:17 AM
Hi
Hope this link will help u.
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml
Thanks
Mahmood
07-16-2007 12:48 AM
Hi
Well i think u can xmodem procedure for this.
Thanks
Mahmood
07-16-2007 12:51 AM
Thanks Mahmood. Have you an idea where I can to find the procedure?
07-16-2007 01:17 AM
Hi
Hope this link will help u.
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml
Thanks
Mahmood
07-16-2007 05:54 AM
If you have physical access to the router, change the speed of the console port to as fast as you can get (I've only been able to get up to about 115000), then once you've got that working, just issue a copy xmodem flash. I'd recommend hyperterminal for this as it has a good send feature.
HTH,
Shane
07-16-2007 06:24 AM
It's right, thanks to all for your helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: