Solved: EM-HDA-6FXO cisco module :Type of cable and connector

implementation_ipt · ‎07-16-2007

Hi,

Please could someone give me the type of cable and connector which I have to connect to the EM-HDA-6FXO module in other to connect the PSTN lines to a Cisco voice gateway 2821 ?

Thanks in advance !

paolo bevilacqua · ‎07-16-2007

Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:

http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml

Else, any RJ21 cable and patch panel will work.

As a recognition to those providing answers, please rate useful posts using the scrollbox below!

View solution in original post

paolo bevilacqua · ‎07-16-2007

Hi,

that module does not have connectors because it is inserted as daughterboard into another module called EVM-HD-8FXS/DID. It cannot be used without.

If you need 6 FXO ports, and do not want the mdoule above, use 1 x VIC2-2FXO and 1x VIC2-2FXO.

Hope this helps, please rate post if it does!

implementation_ipt · ‎07-16-2007

Please,

Can you tell me which connector and cable do I have to connect to EVM-HD-8FXS/DID module in other to connect PSTN lines to a voice gateway ?

Regards,

paolo bevilacqua · ‎07-16-2007

Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:

http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml

Else, any RJ21 cable and patch panel will work.

As a recognition to those providing answers, please rate useful posts using the scrollbox below!