07-16-2007 02:22 AM - edited 03-14-2019 10:34 PM
Hi,
Please could someone give me the type of cable and connector which I have to connect to the EM-HDA-6FXO module in other to connect the PSTN lines to a Cisco voice gateway 2821 ?
Thanks in advance !
Solved! Go to Solution.
07-16-2007 03:05 AM
Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:
http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml
Else, any RJ21 cable and patch panel will work.
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
07-16-2007 02:51 AM
Hi,
that module does not have connectors because it is inserted as daughterboard into another module called EVM-HD-8FXS/DID. It cannot be used without.
If you need 6 FXO ports, and do not want the mdoule above, use 1 x VIC2-2FXO and 1x VIC2-2FXO.
Hope this helps, please rate post if it does!
07-16-2007 03:00 AM
Please,
Can you tell me which connector and cable do I have to connect to EVM-HD-8FXS/DID module in other to connect PSTN lines to a voice gateway ?
Regards,
07-16-2007 03:05 AM
Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:
http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml
Else, any RJ21 cable and patch panel will work.
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: