07-16-2007 02:22 AM - edited 03-14-2019 10:34 PM
Hi,
Please could someone give me the type of cable and connector which I have to connect to the EM-HDA-6FXO module in other to connect the PSTN lines to a Cisco voice gateway 2821 ?
Thanks in advance !
Solved! Go to Solution.
07-16-2007 03:05 AM
Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:
http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml
Else, any RJ21 cable and patch panel will work.
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
07-16-2007 02:51 AM
Hi,
that module does not have connectors because it is inserted as daughterboard into another module called EVM-HD-8FXS/DID. It cannot be used without.
If you need 6 FXO ports, and do not want the mdoule above, use 1 x VIC2-2FXO and 1x VIC2-2FXO.
Hope this helps, please rate post if it does!
07-16-2007 03:00 AM
Please,
Can you tell me which connector and cable do I have to connect to EVM-HD-8FXS/DID module in other to connect PSTN lines to a voice gateway ?
Regards,
07-16-2007 03:05 AM
Preferentially, you will need the BlackBox JPM2194A patch panel with RJ21 cables, as indicated in the data sheet:
http://cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c487.shtml
Else, any RJ21 cable and patch panel will work.
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide