Solved: CCM to CME connection...last question

thompson_usmc · ‎07-16-2007

If i configure the router running CME as an H323 gateway on the CCM will i also need to put the H323 commands on the router itself even though we are not using a gatekeeper?

i.e. h323-gateway voip interface

h323-gateway voip id

h323-gateway voip h323-id....

thanks for the help....

mchandak · ‎07-16-2007

No, you dont have to do this. You can configure the dial-peer to point to CM and on the CM add the Router as an H.323 Gateway, this should take care of things. Only thing that you can do is to do a h323 bind to aviod one way audio issues. Check the following link for information about the same:

http://www.cisco.com/en/US/customer/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml#h323

View solution in original post

mchandak · ‎07-16-2007

No, you dont have to do this. You can configure the dial-peer to point to CM and on the CM add the Router as an H.323 Gateway, this should take care of things. Only thing that you can do is to do a h323 bind to aviod one way audio issues. Check the following link for information about the same:

http://www.cisco.com/en/US/customer/tech/tk652/tk698/technologies_tech_note09186a008009484b.shtml#h323