Connection to Pix Issues

Unanswered Question
Jul 16th, 2007

Hi,

I have two Pix firewalls in HA mode (Active/Standby). I can connect to the active firewall (F1) but not to the standby firewall (F2). I can ping the firewall F2 and the shaow fail advised that it is there and in standby mode. If i swop the firewalls so that the active becomes the standby using the failover command then i can connect to the new active firewall f2 but i cannot connect to the new standby firewall F1.

Has anyone seen this before?

I am using Version 7

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion