Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
321
Views
0
Helpful
3
Replies

optimize WAN VPN connection

slayerhawk
Level 1
Level 1

‎07-16-2007 09:03 AM - edited ‎03-03-2019 05:53 PM

Hi all. I have a PIX 515 that accepts inbound vpn connections from 1750 routers. I have one or two locations complaining about slow email response when sending emails. How can I optimize these routers for better WAN performance? Are there particular counters that I should be looking at for determining any bottlenecks, etc?

Labels:
0 Helpful
3 Replies 3

spremkumar
Level 9
Level 9

‎07-17-2007 04:02 AM

Hi

You can monitor the interface utilisation on the routers kept at the remote end to make sure that they are not choking the entire bandwidth subscribed from your ISP.

regds

0 Helpful

slayerhawk
Level 1
Level 1
In response to spremkumar

‎07-17-2007 04:50 AM

Which commands do I use for that?

0 Helpful

spremkumar
Level 9
Level 9
In response to slayerhawk

‎07-17-2007 04:54 AM

Hi

On the routere end you can make use of show interface serial x/x (serial x/x connected to the external world)you can even reduce the load interval to less than 5 mins which is by default using load-interval 30 which is the minimum value u can set under the interface...

regds

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card