Site to Site VPN using PPPOE

Unanswered Question
Jul 16th, 2007

I have configured a remote 1811 router using a PPPOE connection back to HQ. Previously, it had a split tunnel configuration but I have changed it to have all traffic including web traffic to go over the tunnel. The tunnel is up but I am seeing timeouts and some latency. I have not seen any examples of PPPOE without configuring NAT? I am wondering if I have set this up incorrectly. Attached is the configuration of the remote 1811. Thanks.

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbayuka Fri, 07/20/2007 - 12:21

Add the proper route map to bypass the NAT process on the router if VPN doesnt come up.

Actions

This Discussion