07-16-2007 02:36 PM - edited 02-21-2020 03:09 PM
hi guys,
i have 2 ASA connected via IPSec tunnel wanna configure IPSec for 2 LAN. at the LAN we have public IP's . which means i need to configure transport mode VPN. can anyone send me a link or the basic config.
regards
07-20-2007 12:25 PM
Even though the router is configured for transport mode, the router will request transport mode from its peer however it will still accept either transport or tunnel mode. Take a look at
http://www.cisco.com/en/US/docs/ios/12_0/security/command/reference/sripsec.html#wp1032317
11-30-2016 01:06 AM
Hi vkapoor,
Done that. The tunnel stays up for 37 seconds, with routing information passing, then T5 on the remote 1921 changes state to down again.
thanks.
07-20-2007 08:44 PM
Hello,
By having two public IP's doesn't mean that should build your VPN tunnel using ESP+transport mode, this is only recommended when using GRE over IPSec or DMVPN to save overhead, 20 bytes.
My suggestion is to build the legacy L2L, with tunnel mode, you can see this link as a guide:
Regards,
Enrique Quant
07-20-2007 08:45 PM
07-20-2007 08:45 PM
07-20-2007 08:57 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide